Freedom 20

Wing is built with 1/4″ leading and trailing edge sticks, with no notches.

3 degrees of dihedral at each tip.  Place one wing flat on the table and raise the other tip 2.75″.

Kit includes parts for bolt on wings.  There’s a 1/4″ ply anchor plate for the fuselage, and a 1/16″ ply plate for the trailing edge of the wing.

I’m assuming that the average builder will choose to use a nylon engine mount, so this short kit does not include parts to build the wooden mount shown on the plan.  And don’t forget that you’ll need to build your own cowl.

s-l300