![\"DSC_0166\"](\"http:\/\/www.balsaworkbench.com\/wp-content\/uploads\/2017\/03\/DSC_0166.jpg\")
<\/a> ![\"DSC_0164\"](\"http:\/\/www.balsaworkbench.com\/wp-content\/uploads\/2017\/03\/DSC_0164.jpg\")
<\/a><\/p>\nIt looks pretty accurate, but I’m sure there are a few errors here and there. \u00a0If the first side were removed from the building board and the second side built in its place, the errors in the right\u00a0side may not match the errors in the left. \u00a0Also, in the case of this Telemaster, it’s easy enough to attach the braces\u00a0to the inside of the right fuselage side, but attaching them to the left side would be difficult if it is built directly on the plan.<\/p>\n
The solution is to\u00a0build the left side on top of the right. \u00a0Remove the plan from the table and put it away,\u00a0turn the right side over and\u00a0lay it back down on the table. \u00a0Remember the sticks that were attached in the tail section? \u00a0There aren’t any at the nose of the plane, so we’ll have to shim the part with 3\/8″ thick balsa blocks to make it flat.<\/p>\n
There is no need to pin the fuselage side to the table. \u00a0Protect it with a plastic sheet.<\/p>\n Place the parts for the second side on top of the first.<\/p>\n Build the second fuselage side on top and pin it to the first side, to assure that the two sides are identical.<\/p>\n Now you have two matched sides.<\/p>\n When building fuselage sides from sticks, the typical procedure is to build directly over the plan. \u00a0Protect your plan with a sheet of thin plastic. \u00a0My favorite plan protector is the backing sheet from Super Monokote. \u00a0I save the backing … Continue reading <\/a> <\/a><\/p>\n<\/a><\/p>\n<\/a> <\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n","protected":false},"excerpt":{"rendered":"