The Pharaoh from RCM is a lightweight plane with flaps.<\/p>\n
The plan has a few drafting errors.\u00a0 Bulkheads F-4 through F-7 are shown with irregular spacing in the drawing, but my parts are made with the assumption that you will place F-7 at the location shown on the plan and place 4, 5 and 6 with even spacing.<\/p>\n
F-3 looks simple on the plan, but I have altered the outline to allow the lower turtle deck stringer to be flush with the front top deck sheeting below the cockpit.\u00a0 It\u2019s probably a good idea to install the front and rear stringers first, then notch the front sheeting to accommodate the lower turtle deck stringer.<\/p>\n
There are some other oddities in the wing attachment anchors.\u00a0 I assume that if you\u2019re building this plane you\u2019ll need to be a competent builder, but if you have any questions send me an email.<\/p>\n","protected":false},"excerpt":{"rendered":"
The Pharaoh from RCM is a lightweight plane with flaps. The plan has a few drafting errors.\u00a0 Bulkheads F-4 through F-7 are shown with irregular spacing in the drawing, but my parts are made with the assumption that you will … Continue reading